433Mhz Universal Wireless Remote Control Switch AC 110V 220V 1CH Relay Receiver and 433 Mhz Wall Panel Remote RF Transmitter

433Mhz Universal Wireless Remote Control Switch AC 110V 220V 1CH Relay Receiver and 433 Mhz Wall Panel Remote RF Transmitter
  • Продавецwww.prada-handbags-sale.us
  • Список ценUS $23.23piece
  • Продажная ценаUS $23.23piece
  • ДоставкаБесплатная доставка
  • Рейтинги4,5 (674)

Oписание продукта

ACHIP Self Powered Wireless Transmitter Remotes Light Fan Wall Switch RF Receiver Self-Power Battery-Less Remote Control Kit

Energyharvesting technology

Self powered smart switch

 The receiver can receive the RF signal from self-powered wireless switch, and control the output of the load.

This receiver can provide “on” and “off” output of 1-channeled relay.

Can pair with several switch panels in order to realize the smart multi-control.

20171124_163446_001

20171124_163446_000

The self-powered wireless switch is a wireless transmitter without battery, which is used with wireless receiver usually. It can remote-control the receiver, therefore it can remote-control the load (lights, fan, etc.) connected with the receiver.

 

【Package Include】

1x Wireless Receiver

1 x Remote controller (self-powered, No need battery inside,environmental protection)

2 x Instructions

1 x  gummed paper

20171124_163446_003

【Switch Technical Data 】

Power supply:  Self-powered,without extra power supply

Key Type:  on/off or toggle, depends on switch type

Life Time:  >100 000 cycles

Condition:  -20°~60°

 

【Installation and Operation】

Attention:

It cannot be fixed in metal box, near or on the ground and near a big block of metal. Otherwise, it’s difficult for the receiver to receive the radio signal. 

20171124_163446_004

Pairing A New Switch To The Receiver

1. Enter into the pairing mode

2.  2 Ways of pairing

  • Way 1: Keep pressing the control button (as the above photo)  for 3 seconds, until the output light flashes.
  • Way 2: Within 5 seconds of power on of the receiver, press the switch 3 times quickly, and then the output light begins to flash.

3.Press the wireless switch.

 

Note: During pairing, if press control button or no operation is done within 30 second, the receiver will quite pairing mode.

 

Clear the Paired Switch

 ·Way 1: Clear through button 

  Keep pressing the control button for at least 10 seconds until 2 cycle of quick flash appears. At this time all paired switch will be cleared.

· Way 2: Remote Clean

  Within 5 seconds after receiver power on, press the switch 5 times quickly. 2cycle of quick flash will appear on receiver. At this time, the receiver will clean all paired switch.